Warehouse

SOP on Entry and Exit into Dispensing Booth Area

SOP on Entry and Exit into Dispensing Booth Area

Objective: To lay down a procedure for entry, and Exit into Dispensing Area.

Scope: This SOP is applicable for entry, and Exit into Dispensing Area warehouse Department to the formulation plant.

Responsibility: All concerned people entering into Dispensing Area.

Accountability: Warehouse Head shall be accountable for the compliance of the SOP.

Procedure:

Entry Procedure into Dispensing Area:

Enter the Warehouse as per SOP.

All working people supposed to enter Dispensing area shall enter secondary change room for over gowning.

Take and wear fresh nose mask, head gear, dangri, and take a pair of booties and hand gloves.

Disinfect hands with disinfectant solution.

Exit Procedure from Dispensing Area:

Before exit from Dispensing Booth area discard the gloves in waste.

Remove the secondary gowning in the following sequence, hand gloves, booties, dangri, head gears, nose mask, and put it in the bin provided and leave the room.

Pharmaguidances

Share
Published by
Pharmaguidances

Recent Posts

DQ (DESIGN QUALIFICATION) DOCUMENT FOR AHU

DQ (DESIGN QUALIFICATION) DOCUMENT FOR AHU- 4000 CFM / 150 mm wg - SP To… Read More

5 days ago

STEPS TO BE TAKEN IN CASE OF ENVIRONMENTAL FAILURE

ENVIRONMENTAL FAILURE (STEPS TO BE TAKEN IN CASE) PURPOSE: To lay down a procedure for… Read More

5 days ago

SOP ON CAPA (CORRECTIVE ACTION AND PREVENTIVE ACTION)

SOP ON CAPA (CORRECTIVE ACTION AND PREVENTIVE ACTION) PURPOSE: To lay down the standard operating… Read More

1 week ago

SOP OF PRODUCT RECALL

SOP OF PRODUCT RECALL PURPOSE: This procedure covers transmission of information by means of a… Read More

1 week ago

(DQ)DESIGN QUALIFICATION FOR PURE STEAM GENERATION SYSTEM

(DQ)DESIGN QUALIFICATION FOR PURE STEAM GENERATION SYSTEM DQ- The Author signature indicates that this document… Read More

1 week ago

Design Qualification (DQ) Protocol Form Fill Seal

Design Qualification (DQ) Protocol Form Fill Seal Blow-Fill-Seal (BFS) technology is a manufacturing technique used… Read More

1 week ago